W/Harness Inspection

Body Control

Assist Door Module - B1913 Outside Mirror Right vertical Motor or Sensor W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Signal Circuit Inspection

Check for open in harness
1. Ignition "OFF".
2. Disconnect right outside mirror.
3. Measure resistance between terminal "B19" of ADM and terminal "11" of right outside mirror.

Specification : Approx. 0 Ohms





4. Is the measured resistance within specifications?





Check for short in harness
1. Ignition "OFF".
2. Disconnect right outside mirror.
3. Measure resistance between terminal "11" of right outside mirror and chassis ground

Specification : Approx. Infinity Ohms





4. Is the measured resistance within specifications?






Power Supply Circuit Inspection

Motor Power circuit Inspection
1. Check for open in harness
(1) Ignition "OFF".
(2) Disconnect right outside mirror.
(3) Measure resistance between terminal "A1" of ADM and terminal "1" of right outside mirror.
(4) Measure resistance between terminal "A3" of ADM and terminal "2" of right outside mirror.

Specification : Approx. 0 Ohms





(5) Is the measured resistance within specifications?





2. Check for short in harness
(1) Ignition "OFF".
(2) Disconnect right outside mirror.
(3) Measure resistance between terminal "1" of right outside mirror and chassis ground.
(4) Measure resistance between terminal "2" of right outside mirror and chassis ground.

Specification : Approx. Infinity Ohms





(5) Is the measured resistance within specifications?





Sensor Power circuit Inspection
1. Ignition "OFF"
2. Disconnect right outside mirror.
3. Measure voltage between terminal "9" of right outside mirror and chassis ground.

Specification : Approx. 5 V





4. Is the measured voltage within specifications?






Ground Circuit inspection

Check for open in harness
1. Ignition "OFF".
2. Disconnect right outside mirror.
3. Measure resistance between terminal "10" of right outside mirror and chassis ground.

Specification : Approx. 0 Ohms





4. Is the measured resistance within specifications?