Monitor DTC Status

Immobilizer

Immobilizer - P1610 Non-Immobilizer-EMS Connected to an Immobilizer Scantool Diagnostics

Monitor Scantool Data

1. Check status
(1) IG "ON" & Engine "OFF"
(2) Monitor the "ECM Status" Parameter on the Scantool.

Specification : 'LEARNT'





Fig 1) This data show that 3 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA 3 has been learnt
(3) Has the ECM been learnt?






NOTE:
If the EMS is only replaced using an existing key and SMARTRA 3, after replacing the "virgin" or " neutral" EMS, reteaching is possible by key Learning mode of scanner.
When the same PIN used in existing vehicle is only inputted, the SMARTRA 3 Learning and key Learnings are possible.