Fuel Pump: Service and Repair

Removal

1. Preparation
(1) Remove the rear seat cushion .
(2) Open the service cover (A).




(3) Disconnect the fuel pump connector (A).




(4) Start the engine and wait until fuel in fuel line is exhausted.
(5) After engine stalls, turn the ignition switch to OFF position.
2. Disconnect the fuel feed tube quick-connector (A), the vapor tube quick-connector (B), and the canister close valve connector (C).




3. Remove the rubber cover (D).
4. Remove the fuel pump plate cover (A) with the special service tool (SST No.: 09310-2B200), and then remove the fuel pump assembly










Installation

Installation is reverse of removal.

Fuel Pump Plate Cover Tightening :
78.5 - 98.1 N.m (8.0 - 10.0 kgf.m, 57.9 - 72.4lb-ft)

CAUTION:
When installing the fuel pump module, be careful not to get the seal-ring entangled.