General Information

Automatic Transaxle
P0890 TCM Power Relay Circuit Low - General Information

Component Location





General Description

TCM monitors Battery voltage and power circuit usually, in order to maintain optimum condition of each sensors and solenoid-valve.

DTC Description

TCM set this code If detected lower voltage that drive voltage of solenoid valve than available range. (MIL ON : 2 driving Cycle)

DTC Detecting Condition





CAUTION :
1. The function with the higher priority will always take precedence. However, a low-priority is not overruled by a higher priority function.
2. Functions from different priority categories can also run in parallel. It is important to note which function will take precedence in this case.
3. In such an event it is possible for a substitute function with low priority not be carried out if a second, higher-priority function is present. This has been taken into account when compiling the priority list and is international.
4. The mechanical emergency run function must always have the highest priority, since from the electrical standpoint it is the only safe condition.

Signal Waveform & Data








Fig 1) 1st~6th gear shifting : shift control solenoid valve
F I 2) Battery voltage in Idle status