Component Inspection

Automatic Transaxle
P0924 Gear Shift Reverse Actuator Circuit/Open - Component Inspection

Component Inspection

Check BACK-UP LAMP RELAY component resistance
1. IG KEY "OFF", ENGINE "OFF".
2. Disconnect BACK-UP LAMP RELAY.
3. Measure the resistance between BACK-UP LAMP RELAY control terminals (Component side).

Specification : 80±10 Ohms (20 °C)




4. Is the measured resistance within the specification?





Check BACK-UP LAMP RELAY component operation
1. IG KEY "OFF", ENGINE "OFF".
2. Disconnect BACK-UP LAMP RELAY.
3. Supplies random B+ and ground to coil sides of BACK-UP LAMP RELAY. (Component side)
4. Check continuity between BACK-UP LAMP RELAY power supply terminals - 30 and 87. (Component side)

Specification : When power is supplied : Continuity (below 1.0 Ohms)
When power is not supplied : Discontinuity (Infinite Ohms)




5. Is the continuity test within the specification?





** Repeat this process 2 - 3 times.