General Information

Instrument Panel Module (PIC+)

B1971 Parking Position Input Error - General Information

Component Location





General Description

All 13 units which consists of the Body Electrical Control System are linked by CAN* line.
They are IPM (Inter Panel Module), FAM (Front Area Module), PDM (Power Distribution Module), DDM (Drive Door Module), ADM (Assist Door Module), ECW (Electronic Control Wiper), CLU (Cluster), MFSW (Multi Function Switch), PSM (Power Seat Module), SCM (Steering Control Module), PTM (Power Trunk Lid Module), FBWS (Front Back Warning System), DATC (Dual Auto Temperature Control Module).
The steering wheel's Lock/Unlock state from ESCL (Electronic Steering Column Lock) and the related data to starting from EMS are sent to IPM by the serial communication line.
* CAN (Controller Area Network): CAN is serial bus communication type which links not only communication system but also control units each other.
*2 LIN (Local Interconnect Network): LIN is serial communication type which is used in electrical control system. (This is less expensive.)






DTC Description

This code is outputted when the Parking Position Switch is "ON" for 10 sec and above while the vehicle speed is over 2 MPH (3 km/h).

DTC Detecting Condition





Diagnostic Circuit Diagram





Signal Waveform & Data




Fig.1) "Shift Lever P Position" value at P Position after engine start