Repair Procedures

Replacement

Floor Console Replacement
[ M/T ]

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the console upper cover (A).

2. Remove the console tray mat (A).

3. After loosening the mounting bolt and clips, then remove the floor rear console (A).

4. Using a screwdriver or remover, remove the floor console front bezel (A).

5. Disconnect the connectors (A).

6. After loosening the mounting bolts and nut, clips, then remove the floor front console (A).

7. Installation is the reverse of removal.

NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.

[ A/T ]

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Remove the gear knob (A).

2. Using a screwdriver or remover, remove the console upper cover (A).

3. Disconnect the connector (A).

4. Remove the console tray mat (A).

5. After loosening the mounting bolt and clips, then remove the floor rear console (A).

6. Using a screwdriver or remover, remove the floor console front bezel (A).

7. Disconnect the connectors (A).

8. After loosening the mounting bolts and nut, clips, then remove the floor front console (A).

9. Installation is the reverse of removal.

NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.

Armrest Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the rear console cover (A).

2. After loosening the mounting screws, then remove the armrest assembly (A).

3. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.