Rear Wiper Motor

Replacement

1. Detach the wiper cap (A), then remove the rear wiper arm (C) after removing a nut (B).

Tightening torque Nut(B) :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)




2. Remove the rear wiper cap & pad (C) after removing a nut (B) and cover (A).

Tightening torque Nut (A) :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)




3. Open the tailgate then remove the tailgate trim.
4. Disconnect the rear wiper motor connector then remove the rear wiper motor (A) after removing 2 bolts.

Tightening torque Nut :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)




5. Installation is the reverse of removal.

NOTE:
Before installation, be sure that the rear wiper motor is in the park position.
Turn the wiper switch ON and OFF to allow the rear wiper motor to cycle and stop in the park position.

Inspection

Rear Wiper And Nozzle Setting
1. Set the rear washer nozzle on the specified spray position.

[5DOOR]





[WAGON]




2. Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.

Rear Wiper Motor
1. Remove the 4P connector from the rear wiper motor.
2. Connect battery positive (+) and negative (-) cables to terminals 4 and 1 respectively.
3. Check that the motor operates normally. Replace the motor if it operates abnormally.
(1. GND, 2. Switch, 3. Parking, 4. B+)





Automatic Stop Operation Check
1. Operate the motor at low speed using the stalk control.
2. Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
3. Connect terminals 2 and 3.
4. Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1.
5. Check that the motor stops running at the off position.