Keyless Entry: Description and Operation

Description

Keyless Entry System
The keyless entry system allows you to lock and unlock the vehicle with the remote transmitter. When you push the LOCK button, all doors lock. When you push the UNLOCK button, driver door unlock. If the unlock button is pressed a second time right away, the remain doors unlock.

The room lamp, if its switch is in the center position, will come on when you press the UNLOCK button. If you do not open a door, the light will go off in about 30 seconds, the doors will automatically relock. If you relock the doors with the remote transmitter within 30 seconds, the light will go off immediately.

You cannot lock or unlock the doors with the remote transmitter if the key is in the ignition switch.

The system will signal you when the doors lock and unlock by flashing the hazard lamp once when they lock and closed, and twice when they unlock.

Function

Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1. Keyless entry function is performed in a state that key in switch is eliminated from key cylinder
2. LOCK / UNLOCK signals are received from the transmitter and DOOR LOCK / UNLOCK signals are output.

Transmitter(TX) Spec
1. Transmission Distance : 10m or more from outside of the car
2. Registration procedure of the transmitter
(1) In registration mode, it shall be possible to register up to Max 4EA.
(2) At re-registration, data are registered newly after deleting the previous TX DATA





(3) For the registration procedures by using Diagnostic tester, refer to "TRANSMITTER CODE REGISTRATION".
3. Transmitter signal & Receiver specification
(1) Transmission signal
A. Transmit relevant transmission DATA (Transmission frame) twice by pushing TX SW.
B. Only LOCK signal is output when pushing TX LOCK switch and UNLOCK switch at the same time.