Repair Procedures

Replacement

NOTE:
- Put on gloves to protect your hands.
- Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
- Take care not bend or scratch the cover and other parts.

1. Remove the rear transverse trim.

2. Remove the luggage side trim.

3. Disconnect the rear bumper main connector (A).




4. Loosen the trunk inner mounting bolt (A).




5. Disconnect the connector (A), and then loosen the rear combination lamp mounting nuts.




6. Remove the rear combination lamp (A).




7. Loosen the mounting screw and clips.




8. After loosening the rear bumper side's mounting screw, then disconnect the side's.




9. Remove the rear bumper lower mounting clips.




10. Loosen the mounting bolt (A).




11. Remove the rear bumper cover (A).




12. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly.
- Replace any damaged clips.