Trunk / Liftgate: Service and Repair

Replacement

Trunk Lid Replacement

NOTE:
- When removing and installing the trunk lid, an assistant is necessary.
- Wear gloves to protect hands from injury.

1. After loosening the mounting screws, then remove the trunk lid full handle (A).




2. Detach the clips, then remove the trunk lid trim (A).




3. Disconnect the wiring harness (A) and connectors.
4. After loosening the mounting bolts, then remove the trunk lid (B).

Tightening torque :
6.9 - 8.8 N.m (0.7 - 0.9 kgf.m, 5.1 - 6.5 lb-ft)




5. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Trunk lid weatherstrip replacement
1. Remove the trunk lid weatherstrip (A).

CAUTION:
- Do not apply sealant to the body.




2. Installation is the reverse of removal.

NOTE:
- Install the weatherstrip aligned with center line (B).

Trunk lid latch replacement
1. Remove the trunk lid trim.
2. Disconnect the connector (A).
3. After loosening the mounting bolts, then remove the trunk lid latch assembly (B).

Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




4. Installation is the reverse of removal.

NOTE:
- Make sure trunk lid looks/unlocks and opens/closes properly.

Adjustment

1. After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up or down, or right or left.
2. Adjust the trunk lid height by turning the trunk lid overslam bumpers (B).
3. After loosening the striker (C) mounting bolts, adjust the striker by moving it up or down, or right or left.