Repair Procedures

Removal

1. Disconnect (-) terminal from the battery.
2. Remove the under cover (A).




3. Remove the front stabilizer bar (A).





4. Disconnect the ground wire (A) by removing the bolt.




5. Remove the propeller shaft assembly.





6. Disconnect the inhibitor connector (B) and then remove the shift cable (A) by removing nut (C).

Tightening torque :
13.7 - 17.7 N.m (1.4 - 1.8 kgf.m, 10.1 - 13.0 lb-ft)




7. Remove the CKP sensor (A).




8. Disconnect the solenoid valve connector (A).




9. Remove the oil cooler tubes (A).




10. Remove the dynamic damper (A) from the cross member.




11. Remove the dust cover (A).




12. Remove the torque converter mounting bolts (A-6ea) by rotating the crank shaft.

Tightening torque :
45.1 - 52.0 N.m (4.6 - 5.3 kgf.m, 33.3 - 38.3 lb-ft)




13. Using a jack support the transmission assembly.
14. Remove the mounting bolts (A-4ea, B-2ea) lower in the engine side.

Tightening torque :
(A) 42.2 - 48.1 N.m (4.3 - 4.9 kgf.m, 31.1 - 35.4 lb-ft)
(B) 34.3 - 46.1 N.m (3.5 - 4.7 kgf.m, 25.3 - 34.0 lb-ft)




15. Remove the cross member (A) by removing bolts.

Tightening torque :
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)




16. Remove the starter motor mounting bolts (A).

Tightening torque :
(A) 50 - 65 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)




17. Remove the mounting bolts (A) on the transmission side.

Tightening torque:
42.2 - 53.9 N.m (4.3 - 5.5 kgf.m, 31.1 - 39.8 lb-ft)





Installation

1. Installation is the reverse of removal.

NOTE:
After replacement or reinstallation procedure of the automatic transmission assembly, perform the procedures below.
- Adding automatic transmission fluid.
- After servicing the automatic transmission or TCM, clear the diagnostic trouble codes (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting the battery.
When deleting diagnostic trouble code, use the GDS.
- When replacing the automatic transmission, reset the automatic transmissions values by using the GDS.
- After exchanging automatic transmission, input the EOL(End of line).

- Perform TCM learning after replacing the transmission to prevent slow transmission response, jerky acceleration and jerky startup.