Repair Procedures

Inspection

1. Check the damage and operation of the control cable.
2. Check the damage of the boot.
3. Check the damage and corrosion of the bushing.
4. Check the damage or weakening of the spring.

Removal

1. Disconnect (-) terminal from the battery.
2. Loosen the nut (B) and then remove the shift cable (C) by removing the clip (A).





NOTE:
Do not reuse the clip (A).

3. Remove the console assembly.

4. Take off the clip (A) and remove the shift cable assembly (C) by pressing the guide (B).




5. Remove the retainer (A).






Installation

1. Installation is the reverse order of removal.

CAUTION:
- When installing, set room side Shift lever and T/M side manual control lever to N position.
- When installing, adjust the shift cable.
- After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of room lever.

Adjustment

How To Adjust Shift Cable
1. Set room side Shift lever and T/M side manual control lever to N position.
2. Insert the shift cable to the bracket and hold it with a new clip.
3. Push cable to "F" direction shown to eliminate FREE PLAY.
4. Firmly hold the special bolt with a spanner and tighten the nut with the specified torque.

Tightening torque :
13.7 - 17.7 N.m (1.4 - 1.8 kgf.m, 10.1 - 13.0 lb-ft)