Repair Procedures
Replacement
Door Scuff Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Using a screwdriver or remover, remove the front door scuff trim (A).
2. Disconnect the connector (A).
3. Installation is the reverse of removal.
NOTE:
- Make sure the connector is connected properly.
- Replace any damaged clips.
Front Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
1. After loosening the mounting bolt, then remove the front pillar trim (A).
2. Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.
Center Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
1. Remove the rear seat assembly.
2. Remove the front door scuff trim.
3. Remove the front seat belt lower anchor cover (B).
4. After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
5. Remove the cap (B).
6. After loosening the mounting bolt, then remove the rear pillar trim (A).
7. Remove the mounting clips and then center pillar lower trim (A).
8. Remove the front seat belt upper anchor cover (B).
9. After loosening the mounting bolt, then remove the front seat belt upper anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
10. Remove the cap (B).
11. After loosening the mounting bolt, then remove the center pillar upper trim (A).
12. Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.
Rear Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
1. Remove the cap (B).
2. After loosening the mounting bolt, then remove the rear pillar trim (A).
3. Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.
Package Tray Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
1. Remove the rear seat assembly.
2. Remove the front door scuff trim.
3. Remove the cap (B).
4. After loosening the mounting bolt, then remove the rear pillar trim (A).
5. Remove the mounting clips and then center pillar lower trim (A).
6. After loosening the mounting screws and bolts, then remove the luggage partition tray trim (A).
7. After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
8. Remove the rear seat belt upper anchor cover (A).
9. Remove the package tray trim (A).
10. Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.