Fuel Injector Control Module: Service and Repair
Removal
1. Turn the ignition switch off and disconnect the battery negative (-) cable.
2. Disconnect the injector drive box (IDB) connector (A).
3. Remove the left side head lamp.
4. Remove the IDB assembly after removing the bolts (A) and the nuts (B).
Installation
1. Installation is the reverse of removal.
IDB installation bolt/nut:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
IDB bracket installation bolt/nut (on vehicle):
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)