C1210

C1210 ECM

Description
Transmits the following signals via CAN communication to AWD control unit.
^ Accelerator pedal position signal
^ Engine speed signal

DTC Logic

C1210:

DTC CONFIRMATION PROCEDURE

1. DTC REPRODUCTION PROCEDURE

With CONSULT-III
1. Start the engine. Drive the vehicle for a while.
2. Perform AWD control unit self-diagnosis.
Is DTC "C1210" detected?
YES >> Proceed to diagnosis procedure. Refer to "Diagnosis Procedure".
NO >> INSPECTION END

Diagnosis Procedure

1. PERFORM ECM SELF-DIAGNOSIS

With CONSULT-III
Perform ECM self-diagnosis.
Is any DTC detected?
YES >> Check the DTC.
NO >> GO TO 2.

2. PERFORM SELF-DIAGNOSIS

With CONSULT-III
1. Erase AWD control unit self-diagnostic results.
2. Turn the ignition switch OFF.
3. Start the engine. Drive the vehicle for a while.
4. Make sure that malfunction indicator lamp (MIL) turns OFF.
5. Stop the vehicle. Perform AWD control unit self-diagnosis.
Is DTC "C1210" detected?
YES >> Replace AWD control unit.
NO >> Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.