C1710
C1708, C1709, C1710, C1711 TRANSMITTERDescription
The transmitter (1) integrated with a valve is installed on a wheel (2), and transmits a detected air pressure signal by radio wave.
<---: Outside
DTC Logic
C1708-C1711:
DTC CONFIRMATION PROCEDURE
1. DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Drive at a speed of 40 km/h (25 MPH) or more for 10 minutes.
2. Perform BCM self-diagnosis.
Is DTC "C1708", "C1709", "C1710", "C1711" detected?
YES >> Proceed to diagnosis procedure. Refer to "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1. CHECK AIR PRESSURE SIGNAL
With CONSULT-III
1. Start the engine.
2. Select "DATA MONITOR" mode for "AIR PRESSURE MONITOR" with CONSULT-III.
3. Readout the value of "AIR PRESS FL", "AIR PRESS FR", "AIR PRESS RR", "AIR PRESS RL".
Are all tire pressures displayed 0 kPa?
YES >> GO TO 2.
NO >> GO TO 4.
2. CHECK HARNESS BETWEEN BCM AND TIRE PRESSURE RECEIVER
1. Turn the ignition switch OFF.
2. Disconnect BCM harness connector and tire pressure receiver harness connector.
3. Check continuity between BCM harness connector and tire pressure receiver harness connector.
4. Check continuity between BCM harness connector and ground.
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3. CHECK TIRE PRESSURE RECEIVER
Check tire pressure receiver. Refer to WT-36, "Diagnosis Procedure". Tire Pressure Receiver
Is the inspection result normal?
YES >> Check BCM pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
NO >> Replace the tire pressure receiver.
4. CHECK ID REGISTRATION
Perform ID registration of all transmitters. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
Can ID registration? of all transmitters be completed?
YES >> GO TO 5.
NO >> Replace malfunctioning transmitter.
5. CHECK TIRE PRESSURE MONITORING SYSTEM
With CONSULT-III
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT-III "DATA MONITOR" within 15 minutes after stopped vehicle.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace BCM.
Special Repair Requirement
1. CHECK TIRE AIR PRESSURE
Check all tire air pressures. Refer to WT-104, "Tire Air Pressure". [1][2]Specifications
Does all tire pressure data meet the specification?
YES >> GO TO 2.
NO >> Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
2. PERFORM ID REGISTRATION
Perform ID registration. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
>> END