C1716
C1716, C1717, C1718, C1719 TRANSMITTERDescription
The transmitter (1) integrated with a valve is installed on a wheel (2), and transmits a detected air pressure signal by radio wave.
<---: Outside
DTC Logic
C1716-C1719:
DTC CONFIRMATION PROCEDURE
1. DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Drive at a speed of 40 km/h (25 MPH) or more for 10 minutes.
2. Perform BCM self-diagnosis.
Is DTC "C1716", "C1717", "C1718", "C1719" detected?
YES >> Proceed to diagnosis procedure. Refer to "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1. CHECK TIRE PRESSURE
With CONSULT-III
1. Adjust tire pressure to specified value. Refer to WT-104, "Tire Air Pressure". [1][2]Specifications
2. Perform the ID registration of all transmitters. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
3. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
4. Check all tire pressure with CONSULT-III "DATA MONITOR" within 15 minutes after stopped vehicle.
Is tire pressure indicated as 438.60 kPa (4.47 kg/cm2, 63.60 psi) on the "DATA MONITOR" screen?
YES >> Replace malfunctioning transmitter.
NO >> GO TO 2.
2. CHECK TIRE PRESSURE MONITORING SYSTEM
With CONSULT-III
1. Perform the ID registration of all transmitters. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
2. Drive at a speed of 40 km/h (25 MPH) or more for 10 minutes.
3. Check all tire pressures with CONSULT-III "DATA MONITOR" within 5 minutes.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Perform the self-diagnosis, inspect detected malfunction. Refer to WT-12, "AIR PRESSURE MONITOR: Diagnosis Description". Air Pressure Monitor: Consult-III Function (BCM - Air Pressure Monitor)
Component Inspection
1 CHECK TRANSMITTER
With CONSULT-III
1. Adjust tire pressure to specified value. Refer to WT-104, "Tire Air Pressure". [1][2]Specifications
2. Perform ID registration of all transmitters. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
3. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
4. Check all tire pressure with CONSULT-III "DATA MONITOR" within 15 minutes after stopped vehicle.
Is tire pressure indicated as 438.60 kPa (4.47 kg/cm2, 63.60 psi) on the "DATA MONITOR" screen?
YES >> Replace malfunctioning transmitter.
NO >> INSPECTION END
Special Repair Requirement
1. CHECK TIRE AIR PRESSURE
Check all tire air pressures. Refer to WT-104, "Tire Air Pressure". [1][2]Specifications
Does all tire pressure data meet the specification?
YES >> GO TO 2.
NO >> Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
2. PERFORM ID REGISTRATION
Perform ID registration. Refer to WT-6, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
>> END