Section 1 - Installing the MAP Data Master Discs Into the Consult-III

SECTION 1: INSTALLING THE MAP DATA MASTER DISCS INTO THE C-III

^ The audio system update software is contained on the 08-09 Map Data Master Discs (2 disc set - J-48850-MY09).

^ The 08-09 Map Data Master Discs need to be installed on your C-III only once. It is not necessary to install the Data Master Discs each time you perform an audio system update.

^ If 08-09 Map Data Master Discs are already installed in your C-III computer, you can skip to Section 2.





1. Connect the C-III DVD drive to the C-III computer with the USB cable.

2. Turn ON the C-III computer.

3. Open / start ASIST.





4. Select Information Tool Box and HD Navi. Tools.





5. Select Install Map Update





6. Select Installing updated map

7. Insert the Map Data Master Disc 1 into the C-III DVD drive.





8. Confirm the correct name of the DVD drive is displayed (see Figure 1-5).

^ "E" is likely the correct name for the DVD drive.

^ The DVD drive name may be different depending on the drive configuration of your C-III computer.

9. Select START

^ Installation of the update map will start and a progress screen will display.

^ Installation will take several minutes.





^ At about 35% this message will display as shown above.





^ When you get the above message, remove Disc 1; install Disc 2; then select YES.





^ When installation is complete the screen shown in Figure 1-8 will display.

10. Select OK.





11. Select EXIT

12. Remove Disc 2 from the DVD drive.





13. Select the Safely Remove Hardware icon on the "system tray" which is displayed in the bottom right of the C-III computer screen.

^ You may need to click on the "expand arrow" to expand the icon selections.





14. Select Safely remove USB Mass Storage Device - Drive (E:)

^ The drive name will likely be E, but may be different depending on the drive configuration of your C-III computer.





15. Disconnect the C-III DVD drive from the C-III computer.