Front Door Panel: Service and Repair

FRONT DOOR FINISHER

DRIVER SIDE

DRIVER SIDE : Exploded View

INT-11 Exploded View:

DRIVER SIDE : Removal and Installation

CAUTION: Wrap the tip of flat-bladed screwdriver with a cloth before remove.

REMOVAL
1. Fully open door window.





2. Remove inside handle escutcheon (1) with a flatted-blade screwdriver (A) wrapped in a tape as shown in the figure.





3. Remove screw (A) located on the back side of inside handle escutcheon.





4. Remove power window switch finisher (1) fixing screw located under the pull handle cover with a screwdriver (A).





5. Remove step lamp (1) and then disconnect the harness connector.





6. Insert a remover tool (A) between the door finisher and door panel to disengage the clips.

CAUTION: Insert a remover tool (A) into the part shown in the figure. (Between the clips and the door panel)





7. Disconnect lock knob cable (1), inside handle cable (2) and the seat position switch harness connector (A).
8. Disconnect the power window switch finisher harness connectors.
9. Remove the front door finisher.
10. Remove the following parts after removing the front door finisher.
- Front door inside handle.
- Seat memory switch.
- The power window switch finisher.

INSTALLATION
Install in the reverse order of removal.

CAUTION: When installing door finisher, check that clips are securely fitted in panel holes on body, and then press them in.

PASSENGER SIDE

PASSENGER SIDE : Exploded View

INT-14 Exploded View:

PASSENGER SIDE : Removal and Installation

CAUTION: Wrap the tip of flat-bladed screwdriver with a cloth before remove.

REMOVAL
1. Fully open door window.





2. Remove inside handle escutcheon (1) with a flatted-blade screwdriver (A) wrapped in a tape as shown in the figure.





3. Remove screw (A) located on the back side of inside handle escutcheon.





4. Insert a remover tool (A) wrapped into a shop cloth at the bottom edge of front door grip cap to disengage the pawls.
5. Remove front door grip cap.





6. Remove front door grip fixing screws with tool.





7. Remove step lamp (1) and then disconnect the harness connector.





8. Insert a remover tool (A) between the door finisher and door panel to disengage the clips.

CAUTION: Insert a remover tool (A) into the part show in the figure. (Between the clips and the door panel)





9. Disconnect lock knob cable (1) and inside handle cable (2) from door inside handle assembly.
10. Disconnect the power window switch harness connector.
11. Remove the door finisher.
12. Remove the following parts after removing the door finisher.
- Front door inside handle.
- Power window switch finisher.

INSTALLATION
Install in the reverse order of removal.

CAUTION: When installing door finisher, check that clips are securely fitted in panel holes on body, and then press them in.