Front Door Weatherstrip: Service and Repair

DOOR PARTING SEAL

Exploded View

EXT-46 Exploded View:

Removal and Installation

REMOVAL

FRONT DOOR PARTING SEAL
1. Fully open front door.





2. Using a remover tool (A), disengage the clips from the front door parting seal (1).

CAUTION:
- Disengage the clips slowly and carefully.
- Do not pull the front door parting seal strongly.

3. Remove front door parting seal.

REAR DOOR PARTING SEAL (LOWER)
1. Fully open rear door.





2. Using a remover tool (A), disengage the clips from the rear door parting seal (1).

CAUTION:
- Disengage the clips slowly and carefully.
- Do not pull the rear door parting seal strongly.

REAR DOOR PARTING SEAL (FRONT)
1. Fully open front door.
2. Pull back rear door parting seal (front).

CAUTION: Do not bend the rear door parting seal strongly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- When installing door parting seal, check that blind clips are securely fitted in panel holes on body, and then press them in.
- When installing, check visually the fillet molding and the clips, then replace them with new parts if they have been damaged.
- Replace double-faced adhesive tape on back of rear door parting seal (front) with a new tape if rear door parting seal (front) is reused.
- Remove double-faced adhesive tape remaining on body and back of rear door parting seal (front) using double-faced adhesive tape remover when removing rear door parting seal (front).
- Do not wash the vehicle with in 24 hours after installing so as to keep adhesive.