Rear Door Panel: Service and Repair

REAR DOOR FINISHER

Exploded View

INT-17 Exploded View:

Removal and Installation

CAUTION: Wrap the tip of flat-bladed screwdriver with a cloth before remove.

REMOVAL
1. Fully open door window.





2. Remove inside handle escutcheon (1) with a flatted-blade screwdriver (A) wrapped in a tape as shown in the figure.





3. Remove screw (A) located on the back side of inside handle escutcheon.





4. Remove power window switch finisher (1) fixing screw located under the pull handle cover with a screwdriver (A).





5. Insert a remover tool (A) between the door finisher and door panel to disengage the clips.

CAUTION: Insert a remover tool (A) into the part show in the figure. (Between the clips and the door panel)





6. Disconnect lock knob cable (1) and inside handle cable (2) from rear inside handle (3).
7. Disconnect the rear door power window switch harness connector.
8. Remove the rear door finisher.
9. Remove the following parts after removing the door finisher.
- Rear door inside handle.
- Rear door power window switch finisher.

INSTALLATION
Install in the reverse order of removal.

CAUTION: When installing door finisher, check that clips are securely fitted in panel holes on body, and then press them in.