Trunk / Liftgate Interior Trim Panel: Service and Repair

BACK DOOR TRIM

Exploded View

INT-38 Exploded View:

Removal and Installation

REMOVAL

BACK DOOR FINISHER INNER
1. Fully open back door.





2. Remove the clips (A) from the back door finisher inner (1) with tool.





3. Disengage the luggage room lamp fixing pawls with a tool, disconnect the harness connector (A) then remove the lamp (1) (LH/RH)





4. Disengage pull handle finisher (1) fixing pawls with remover tool (A) and then remove pull handle finisher (1).





5. Disengage the back door finisher lid (1) fixing pawls, then remove the back door finisher lid (1) with remover tool (A).
6. Remove the back door finisher inner.





1. Insert remover tool (A) between back door finisher inner (1) and back window glass, pull downwards to disengage clips as shown in the figure.





2. Insert remover tool (A) between back door lower finisher inner (1) and back door panel to disengage the clips.

NOTE: Starting from the lower downwards and works around the edges and up to the sides.

7. Pull out to remove back door finisher inner.





8. Disengage back door plate (1) fixing pawls and metal clips with remover tool (A) and then remove back door plate (1).





9. Disengage back door hinge cover (1) fixing clips with remover tool (A) and then remove back door hinge cover (1).

INSTALLATION
Install in the reverse order of removal.

CAUTION: When installing back door trim, check that clips are securely fitted in panel holes on body, and then press them in.