Floor Trim

FLOOR TRIM

Exploded View

INT-24 Exploded View:

Removal and Installation

REMOVAL
1. Remove front seat (LH/RH).
2. Remove rear seat cushion.
3. Remove accelerator pedal pad.





4. Disengage clip of floor hook (1) with remover tool (A).
5. Remove foot grille (LH/RH).
6. Remove front seat belt floor anchor bolt (LH/RH). Refer to SB-7, "SEAT BELT BUCKLE : Exploded View".
7. Remove center console assembly.
8. Remove instrument lower cover, instrument driver lower panel, instrument assist lower panel and instrument side panel (LH/RH).





9. Remove G-sensor (1).
10. Remove diagnosis sensor unit (2).
11. Remove console rear bracket (3).
12. Remove floor harness mounting clamps (A).
13. Remove dash side finisher (LH/RH), front kicking plate inner (LH/RH) and body side welt (LH/RH).
14. Remove floor trim mounting clips and fixing nuts.





15. Remove floor trim from floor trim fixing clips (A) and remove floor carpet.

INSTALLATION
Install in the reverse order of removal.