Front Door Lock

FRONT DOOR LOCK

DOOR LOCK

DOOR LOCK : Exploded View

DLK-244 Exploded View:

DOOR LOCK : Removal and Installation

REMOVAL
1. Remove front door finisher.
2. Remove front door glass.
3. Remove front door module assembly.
4. Disconnect door antenna and door request switch connector and remove harness clamp (with Intelligent Key system model) on outside handle bracket.




5. Remove door side grommet, and loosen TORX bolt from grommet hole.

CAUTION: Never remove TORX bolt forcibly.




6. Reach in to separate key rod (2) connection [on the door key cylinder assembly (1)] (driver side).




7. While pulling outside handle, remove door key cylinder assembly (driver side) or outside handle escutcheon (passenger side).




8. While pulling outside handle (1), slide toward rear of vehicle to remove outside handle.
9. Remove front gasket and rear gasket.




10. While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket.
11. Reach in to separate outside handle cable connection on outside handle bracket.
12. Remove door lock assembly TORX bolts.
13. Disconnect door lock actuator connector, and then remove door lock assembly.
14. Remove key rod from door lock assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- When installing each rod, rotate rod holder until a click is felt.
- Check door open/close, lock/unlock operation after installation.