Condenser

CONDENSER

Exploded View

HA-53 Exploded View:

Removal and Installation

REMOVAL
1. Remove condenser pipe assembly.




2. Remove mounting bolts (A) and nut (B), and then remove radiator core support bracket (1).
3. Disconnect refrigerant pressure sensor connector (A) and harness clips (B).









4. Pull condenser (1) upward of vehicle, and then remove condenser (as shown in the figure).

CAUTION: Be careful not to damage core surface of condenser.

INSTALLATION
Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a click is heard.
- After piping connection is completed, pull male-side piping by hand to make sure that connection does not come loose.
- Check for leakages when recharging refrigerant.