Front Passenger Air Bag Module

FRONT PASSENGER AIR BAG MODULE

Exploded View

SR-8 Exploded View:

Removal and Installation

WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.
- Always work from the side of air bag module. Do not work in front of it.
- Do not use air tools or electric tools for servicing.

REMOVAL
1. Remove the instrument panel assembly.




2. Remove the front passenger air bag module fixing screws (A).
3. Disconnect pawls, and then remove front passenger air bag module (2) from instrument panel assembly (1).

CAUTION:

- Always place front passenger air bag module with pad side facing upward.
- Do not insert any foreign objects (screwdriver, etc.) into front passenger air bag module.
- Do not disassemble front passenger air bag module.
- Do not expose the front passenger air bag module to temperatures exceeding 90 °C (194 °F).
- Do not allow oil, grease or water to come in contact with the front passenger air bag module.

- Replace the front passenger air bag module if it has been dropped or sustained an impact.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Do not use old fixing bolt after removal; replace with new bolt.
- In the case that a malfunction is detected by the air bag warning lamp, after reparation or replacement of the malfunctioning parts, reset the memory by self-diagnosis or by the CONSULT-III.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp. Refer to SRC-14, "Diagnosis Description". Initial Inspection and Diagnostic Overview