Crash Zone Sensor

CRASH ZONE SENSOR

Exploded View

SR-12 Exploded View:

Removal and Installation

WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.
- Do not use air tools or electric tools for servicing.

REMOVAL
1. Remove the reservoir tank.
2. Remove the crash zone sensor fixing nuts.
3. Disconnect crash zone sensor harness connector.

CAUTION:
- Do not use old fixing nuts after removal; replace with new nuts.

- Replace the crash zone sensor if it has been dropped or sustained an impact.
- Replace the crash zone sensor of deployed driver air bag and deployed front passenger air bag.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- In the case that a malfunction is detected by the air bag warning lamp, after reparation or replacement of the malfunctioning parts, reset the memory by self-diagnosis or by the CONSULT-III.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp. Refer to SRC-14, "Diagnosis Description". Initial Inspection and Diagnostic Overview