Front Drive Shaft and Drive Chain
FRONT DRIVE SHAFT AND DRIVE CHAINDLN-67 Exploded View:
Disassembly
1. Separate front case and rear case.
2. Remove drive chain and front drive shaft while tapping front rive shaft with plastic hammer.
CAUTION: Never tap drive chain.
3. Remove front drive shaft front bearing with the drift (A) and puller (B).
A: Drift [SST: ST31214000 (J-25269-B)]
B: Puller (commercial service tool)
4. Remove front drive shaft rear bearing with the drift (A) and puller (B).
A: Drift [SST: ST31214000 (J-25269-B)]
B: Puller (commercial service tool)
Assembly
1. Install front drive shaft front bearing with the drift (A) [SST: ST33200000 (J-26082)].
2. Install front drive shaft rear bearing with the drift (A) [SST: KV38104010 ( - )].
3. Install drive chain to front drive shaft.
CAUTION: Identification mark (A) of drive chain should be in the side of front bearing (1) of front drive shaft.
4. Install drive chain to mainshaft, and then install by tapping front rive shaft with plastic hammer. Press-fit rear bearing of front rive shaft to rear case.
CAUTION: Never tap drive chain.
5. Install front case to rear case.
Inspection
Check items below. If necessary, replace them with new ones.
CASES
^ Contact surfaces of bearing for wear, damage, etc.
^ Damage and cracks of case.
BEARING
^ Damage and rough rotation of bearing.
SHAFT
^ Damage, peeling, dent, uneven wear, bending, etc. of shaft.
GEARS AND CHAIN
^ Excessive wear, damage, peeling, etc. of gear and chain.