C1F05

C1F05 ACCELERATOR PEDAL ACTUATOR POWER SUPPLY CIRCUIT





Description
Power is supplied from ignition power supply and battery power supply to the accelerator pedal actuator.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine.
2. Turn the DCA system ON.
3. Perform "All DTC Reading" with CONSULT-III.
4. Check if the "C1F05" is detected as the current malfunction on the self-diagnosis results of "ICC/ADAS" or "ACCELE PEDAL ACT".
Is "C1F05" detected as the current malfunction?
YES - SEE Diagnosis Procedure.
NO - Intermittent Incident.




Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUIT
Check the accelerator pedal actuator power supply circuit. Accelerator Pedal Actuator.
Is the inspection result normal?
YES - Replace the accelerator pedal assembly.
NO - Repair or replace the malfunctioning parts.




Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement, "ACCELERATOR PEDAL
RELEASED POSITION LEARNING : Description".
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. ( Description(Distance Control Assist) for action test.)
2. Check that the DCA system is normal.
- WORK END