C1A28
C1A28 BCU POWER SUPPLY CIRCUIT, C1A29 BCU POWER SUPPLY CIRCUIT2
Description
The brake booster control unit controls the brake booster, etc. with the battery power supply and ignition power supply.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC "C1A28" or "C1A29" is detected along with DTC "U1000", first diagnose the DTC "U1000". Refer to
Distance Control Assist System.
DTC CONFIRMATION PROCEDURE
1. PERFORM DTC CONFIRMATION PROCEDURE
1.Start the engine.
2.Turn the DCA system ON.
3.Perform "All DTC Reading" with CONSULT.
4.Check if the "C1A28" or "C1A29" is detected as the current malfunction in self-diagnosis results of "ICC/
ADAS".
Is "C1A28" or "C1A29" detected as the current malfunction?
YES- .
NO- Intermittent Incident.
Diagnosis Procedure
1. CHECK SELF-DIAGNOSIS RESULTS
Check if "U1000" is detected other than "C1A28", "C1A29" in "Self Diagnostic Result" of "ICC/ADAS".
Is "U1000" detected?
YES- Perform the CAN communication system inspection. Repair or replace the malfunctioning parts.
Distance Control Assist System.
NO- GO TO 2.
2. CHECK BRAKE BOOSTER CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Check brake booster control unit power supply and ground circuit. Distance Control Assist System.
Is the inspection result normal?
YES- Replace the brake booster control unit.
NO- Repair brake booster control unit power supply and ground circuit.
Special Repair Requirement
DESCRIPTION
Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following operation is performed.
- Removal and installation of ICC sensor integrated unit
- Replacement of ICC sensor integrated unit
SPECIAL REPAIR REQUIREMENT
1. LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT
Adjust the laser beam aiming of the ICC sensor integrated unit. Description.
- GO TO 2.
2. CHECK DCA SYSTEM
1.Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. (Description (Distance Control Assist) for action test.)
2.Check that the DCA system is normal.
- WORK END