Special Repair Requirement (Camera Aiming Adjustment)

INSPECTION AND ADJUSTMENT

CAMERA AIMING ADJUSTMENT : Special Repair Requirement (Camera Aiming Adjustment)


CAUTION:
Perform the adjustment under unloaded vehicle condition.

1. CHECK VEHICLE HEIGHT






Measure the wheel arch height. Calculate "Dh".





NOTE:
"Dh" may be calculated as a minus value.
- GO TO 2.

2. CAMERA AIMING ADJUSTMENT

CONSULT WORK SUPPORT

CAUTION:
Operate CONSULT outside the vehicle, and close all the doors. (To retain vehicle attitude appropriately)
1.Select "Work Support" on "LANE CAMERA" with CONSULT.
2.Select "AUTO AIM".
3.Confirm the following items;
-The target should be accurately placed.
-The vehicle should be stopped.
4.Select "Start" to perform camera aiming.

CAUTION:
Never select "Start" when the target is not accurately placed.
5. Input "Dh", and then select "Start".

CAUTION:
Never change "Ht" and "Dt".
6.Confirm the displayed item.
-"Normally Completed": Select "Completion".
-"SUSPENSION" or "ABNORMALLY COMPLETED": Perform the following services.





7.Confirm that "Normally Completed" is displayed and then select "End" to close the aiming adjustment procedure.
- GO TO 3.

3. PERFORM SELF-DIAGNOSIS

Perform self-diagnosis of lane camera unit with CONSULT.
Is any DTC detected?
YES- Perform diagnosis on the detected DTC and repair or replace the applicable item. A L L Diagnostic Trouble Codes ( DTC ).
NO- GO TO 4.

4. ACTION TEST

Test the LDW/LDP system operation by action test. LDW & LDP.
- WORK END