Automatic Drive Positioner Control Unit

POWER SUPPLY AND GROUND CIRCUIT

AUTOMATIC DRIVE POSITIONER CONTROL UNIT : Diagnosis Procedure

NOTE:
Do not disconnect the battery negative terminal and the driver seat control unit connector until DTC is confirmed with CONSULT.
Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.

1. CHECK POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit.
3.Check voltage between automatic drive positioner control unit harness connector and ground.
Revision: March 20122013 Infiniti JX





Is the inspection result normal?
YES- GO TO 2.
NO-Check the following.
- Repair or replace harness.
- Circuit breaker.

2. CHECK GROUND CIRCUIT

Check continuity between the automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Inspection End.
NO- Repair or replace harness.