Seat Occupant Classification Module - Air Bag: Service and Repair

OCCUPANT CLASSIFICATION SYSTEM

Removal and Installation


OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT


WARNING:
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use air tools or electric tools for servicing.
Removal
1.Remove passenger seat assembly. Refer to "Removal and Installation" Removal and Installation.
2.Remove occupant classification system control unit bolts.
3.Disconnect the harness connector from the occupant classification system control unit.
4.Remove occupant classification system control unit.

CAUTION:
- Replace the occupant classification control unit if it has been dropped or sustained an impact.
- Do not strike the occupant classification control unit.
Installation
Installation is in the reverse order of removal.

CAUTION:
- Do not damage the harness connector during installation.
- After installation is complete, check that no system malfunction is detected causing the air bag warning lamp to illuminate.
- If a malfunction is indicated by the air bag warning lamp after repair or replacement of the malfunctioning parts, perform the SRS final check. Refer to "SRS Final Check" SRS Final Check.

OCCUPANT CLASSIFICATION SYSTEM SENSORS

The occupant classification system sensors are part of the front seat frame. For removal and installation of the front seat frame, refer to "Disassembly and Assembly" Disassembly and Assembly.
Revision: March 20122013 Infiniti JX