Transmission Position Sensor/Switch: Adjustments

Inhibitor Switch Location:

Inhibitor Switch Adjustment:

1. Remove control cable end from manual shaft.
2. Set manual shaft in "N" position.
3. Loosen inhibitor switch fixing bolts.
4. Insert 4.0 mm (0.157 in) dia. pin into adjustment holes in both inhibitor switch and manual shaft as near vertically as possible.
5. Tighten inhibitor switch fixing bolts.
6. Remove pin from adjustment holes after adjusting inhibitor switch.
7. Reinstall any part removed.
8. Adjust control cable.
9. Check continuity of inhibitor switch.