Sub-Crankshaft Position Sensor

Crankshaft Position Sensor:

1. Remove the Crankshaft Position Sensor from the engine. Leave distributor harness CONNECTED.
2. Disconnect all of the ignition wires from the distributor cap and turn the ignition switch ON.
3. Using a volt meter set in 100mV range, check voltage between terminal A and B-(ground), while rotating it slowly by hand.
Tester pointer deflects: OK
Tester pointer DOES NOT deflect: NG
4. If NG, replace Crankshaft Position Sensor

NOTE: This test may set Code 11. Be sure to clear the ECCS Control Module's memory after repairs are finished.