Operative Condition

Outside door mirrors are adjusted using the following three systems.

Manual Remote Control:
The power door mirror system consists of a Door Mirror Remote control switch, mounted on the lower left side of the instrument panel.

Two motors are included in each door mirror.

One motor controls the horizontal position of the power mirror the other controls the vertical position of the power mirror.

To adjust the door mirror set the selector knob on the Remote Control switch to the "L" position to adjust the driver side mirror or to the "R" position to adjust the passenger side mirror when the ignition key is "ACC". Move the knob up, down, left, or right until the mirror is in the desired position. Return the selector knob to the center position after setting.

Automatic Drive Positioner System:
This system adjusts the driver's seat position, tilt and telescopic adjustment of the steering wheel and the left and right door mirrors. Outside Door Mirror Automatic Tilt Down Reverse System:

This system controls the door mirrors so that they face downward to assure rearward visibility while the vehicle is being backed up.

Door mirror is set to the appropriate position for reversing by moving the door mirror selector knob to "L" or "R" and A/T selector lever to "R" position when the ignition switch is ON.

Door mirrors are set to downward position already retained in memory using the automatic drive positioner memory switch 1 or 2. If door mirror positions are not retained in memory, moving the door mirror selector knob to "L" or "R" sets the corresponding door mirror from the current position to the standard downward position for reversing.

Note: In any of the following situations, the reverse system will be canceled and the door mirrors will not move even though the A/T selector lever is positioned to "R".

a. Ignition switch is turned "OFF".
b. Driver's door is opened.
c. The vehicle speed is over 24 kph (15 mph)

In order to reset the reverse system, move the door mirror selector knob to "Neutral (Center)" once and then move it to "L" or "R" while not in any of the three situations (a, b, c) above.