Sub-Camshaft Position Sensor

***THIS ARTICLE INCLUDES UPDATES MADE BY TSB #IBT94-024, DATED APRIL 28, 1994***

1994 Q45 CAMSHAFT POSITION SENSOR
APPLIED VIN:
With full-active suspension, JNKNG01DXRM263359
Without full-active suspension, JNKNG01DXRM263418
APPLIED DATE:
From November 1993 production
SERVICE INFORMATION:
The sub-camshaft position sensor (built into the camshaft position sensor) has been eliminated beginning with the applied VINs. Therefore, the sub-camshaft position sensor information will not be applicable on these models.

While rotating Camshaft Position
Sensor shaft slowly by hand:
Voltage between terminal A and B-(ground) tester pointer deflects

NOTE: This test may set Code 11. Be sure to clear the ECCS Control Module's memory after repairs are finished.
NOTE: Use a volt meter set in 100mV range.