Without Scan Tool

WHEN CONSULT IS NOT USED

(1) Procedures
- Turn ignition switch "ON". (Do not start engine.)






- Set height control switch (on floor console) from "N" (normal) to "H" (high). Repeat above operation at least ten times within ten seconds after turning ignition switch "ON". Then return height control switch to "N".
- After all self-diagnostic requirements are met, the active suspension warning lamp flashes and self-diagnosis starts.

NOTE: If more than two system lines are faulty, only one of the faulty system lines is indicated in order of priority. The warning lamp may remain on depending upon types of abnormalities (such as those in control unit, etc.). In this case, conduct self-diagnosis using CONSULT.

(2) How to read self-diagnostic indications






- Read both ten's and unit digits from number of flashes on active suspension warning lamp. (Refer to figure at left.)
- Determine location of fault in accordance with Malfunction Code tables below.

(3) Malfunction code table: