Keyless Entry: Service and Repair

Enter the ID manually when:
^ Remote controller or controller unit needs to be replaced.
^ An additional remote controller needs to be installed.

ID Code Entry Procedure
To enter the ID code, follow this procedure.
"Setting mode".

Three steps must be followed to establish the "setting mode".
1. Open the trunk.
2. Close and lock all doors.
3. Insert and remove the key from the ignition more than six times within 10 seconds.
^ At this time, the original ID codes are eliminated.

ID code entry:
4. Unlock and lock the driver's door inside lock lever once.
5. Push lock button on the new remote controller once (for example, if door is locked using the remote controller during this ID code entry enable state, a new ID code can be entered).
^ At this time, the new ID code is entered.
6. If you need to enter additional remote controllers, repeat steps (4) and (5) for each controller.
7. This ID code entry enable state and setting mode remain until any one of the doors is opened. Note
^ If the same ID code that exists in the memory is input, the entry is canceled.
^ Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.
^ Any ID codes entered after termination of the "setting" mode will not be accepted. Additionally remote control signals will be inhibited when an ID code has not been entered during the "setting" mode.