Reading and Clearing Diagnostic Trouble Codes

1. Turn Ignition switch "OFF" .
2. Connect "CONSULT" to the data link connector.




3. Turn Ignition switch "ON" .
4. Touch "START".




5. Touch "IVMS"




6. Touch "MULTI-REMOTE CONT SYS"




^ DATA MONITOR, and ACTIVE TEST are available for the multi-remote control system

Trouble Diagnoses




Work Flow

NOTE
^ When Local Control Unit (LCU) connectors are disconnected for more than 1 minute such as during trouble diagnoses, the "disconnected" data will be memorized by the Body Control Module (BCM). Therefore, after reconnecting the LCU connectors, erase the memory
^ To erase the memory, perform the procedure below. Erase the memory with CONSULT or turn the ignition switch to "OFF" position and remove 7.5 A fuse (No. (14), located in the fuse and fusible link box).

Trouble Symptom




^ All functions of remote control system do not function.




^ Multi-remote controller does not operate a part of the functions.

NOTE:
^ The unlock and trunk open operation of multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder
^ The lock operation of multi-remote control system does not activate with the key inserted in the ignition key cylinder or if one of the doors is opened.





Diagnostic Procedure 1
NOTE: Remote controller does not function if battery is not set correctly.





Diagnostic Procedure 2








Diagnostic Procedure 3





Diagnostic Procedure 4





Diagnostic Procedure 5





Diagnostic Procedure 6