Shift Control Components

INSPECTION








^ Check contact surface and sliding surface for wear, scratches, projections or other damage.

ADJUSTMENT OF INPUT SHAFT BRAKING MECHANISM





1. Install striking lever & rod, striking interlock assembly and control bracket on clutch housing exactly.





2. Measure maximum height "H" while shifting from neutral to reverse position.
Maximum height "H": 67.16 - 67.64 mm (2.6441 - 2.6630 inch)





3. Remove control bracket from clutch housing.
4. Measure clearance "C" between reverse brake cam and striking lever at reverse position.
Clearance "C": 0.05 - 0.125 mm (0.0020 - 0.0049 inch)
5. If "H" and "C" are not within specifications, replace the following as a set.
^ Striking lever assembly
^ Striking interlock assembly (This includes reverse brake cam.)
^ Control bracket assembly