| Surface Flatness | | | |
| Standard | | Less Than 0.03 Millimeter (mm) |
| Limit | | 0.10 Millimeter (mm) |
| Cylinder Bore Inner Diameter | | | |
| Standard | | |
| | Grade No.1 | 93.000 - 93.010 Millimeter (mm) |
| | Grade No.2 | 93.011 - 93.020 Millimeter (mm) |
| | Grade No.3 | 93.021 - 93.030 Millimeter (mm) |
| Wear Limit | | 0.20 Millimeter (mm) |
| Out of Round (X- Y) | | | Less Than 0.015 Millimeter (mm) |
| Taper (A - B - C) | | | Less Than 0.015 Millimeter (mm) |
| Main Journal Inner Diameter | | | |
| Grade No. A | | 63.993 - 63.994 Millimeter (mm) |
| Grade No. B | | 63.994 - 63.995 Millimeter (mm) |
| Grade No. C | | 63.995 - 63.996 Millimeter (mm) |
| Grade No. D | | 63.996 - 63.997 Millimeter (mm) |
| Grade No. E | | 63.997 - 63.998 Millimeter (mm) |
| Grade No. F | | 63.998 - 63.999 Millimeter (mm) |
| Grade No. G | | 63.999 - 64.000 Millimeter (mm) |
| Grade No. H | | 64.000 - 64.001 Millimeter (mm) |
| Grade No. J | | 64.001 - 64.002 Millimeter (mm) |
| Grade No. K | | 64.002 - 64.003 Millimeter (mm) |
| Grade No. L | | 64.003 - 64.004 Millimeter (mm) |
| Grade No. M | | 64.004 - 64.005 Millimeter (mm) |
| Grade No. N | | 64.005 - 64.006 Millimeter (mm) |
| Grade No. P | | 64.006 - 64.007 Millimeter (mm) |
| Grade No. R | | 64.007 - 64.008 Millimeter (mm) |
| Grade No. S | | 64.008 - 64.009 Millimeter (mm) |
| Grade No. T | | 64.009 - 64.010 Millimeter (mm) |
| Grade No. U | | 64.010 - 64.011 Millimeter (mm) |
| Grade No. V | | 64.011 - 64.012 Millimeter (mm) |
| Grade No. W | | 64.012 - 64.013 Millimeter (mm) |
| Grade No. X | | 64.013 - 64.014 Millimeter (mm) |
| Grade No. Y | | 64.014 - 64.015 Millimeter (mm) |
| Grade No. 4 | | 64.015 - 64.016 Millimeter (mm) |
| Grade No. 7 | | 64.016 - 64.017 Millimeter (mm) |
| Difference in Inner Diameter Between Cylinders | | | |
| Standard | | Less Than 0.03 Millimeter (mm) |