With Manufacturer's Scan Tool (CONSULT-II)

1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" to the data link connector.




3. Insert UEN99A program card into CONSULT-II.
4. Turn ignition switch "ON".
5. Touch "START".




6. Touch "IVCS".




7. Perform each diagnostic item according to the item application chart as follows:
8. When CONSULT-II inspection is terminated, follow the procedure shown below.
a. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears, then turn off CONSULT-II.
b. Turn ignition switch to OFF position.
c. Disconnect CONSULT-II DDL connector.

NOTE: If the DDL connector is disconnected before turning ignition switch to "OFF" position, INFINITI communicator may not operate properly.