Pinout Values and Diagnostic Parameters

ECM Terminals and Reference Value

PREPARATION




1. ECM is located behind the center console. For this inspection:
- Remove the front passenger center console panel.

2. Remove ECM harness protector.




3. Perform all voltage measurements with the connector connected. Extend tester probe as shown to perform tests easily.
- Open harness securing clip to make testing easier.
- Use extreme care not to touch 2 pins at one time.
- Data is for comparison and may not be exact.

CAUTION: Do not use ECM ground terminals when measuring input/ output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.

ECM Harness Connector Terminals Layout:

ECM HARNESS CONNECTOR TERMINALS LAYOUT

Part 1:

Part 2:

Part 3:

Part 4:

Part 5:

Part 6:

Part 7:

ECM INSPECTION TABLE
Specification data are reference values and are measured between each terminal and ground.

CAUTION: Do not use ECM ground terminals when measuring input/ output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.