Backup Lamp: Service and Repair

Bulb Replacement
REAR COMBINATION LAMP






Removal
1. Open the trunk and remove the trunk side finisher. Refer to "TRUNK ROOM TRIM and TRUNK LID FINISHER".
2. Disconnect the rear combination lamp connector.
3. Remove the rear combination lamp mounting nuts.
4. Pull the rear combination lamp toward rear of the vehicle and remove from the vehicle.
5. Remove the seal packing from the vehicle.


Installation
Install in the reverse order of removal, taking care of the following points

Install a new seal packing to the rear combination lamp.

CAUTION: Seal packing cannot be reused.

Rear combination lamp mounting nut:
Tightening Torque : 2.5 - 3.8 N.m (0.26 - 0.38 kg-m, 23 - 33 in-lb)