CONSULT-II Inspection Procedure

CONSULT-II Inspection Procedure




1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVETER to data link connector.




3. Turn ignition switch ON.
4. Turn ASCD main switch ON.
5. Touch START (NISSAN BASED VHCL) (on CONSULT-II display).
6. Touch ASCD.
If "ASCD" is not indicated,




7. Touch SELF-DIAG RESULTS.




- Self-diagnostic results are shown on display.
Refer to "CONSULT-II Self-diagnostic Results" table.



8. Touch DATA MONITOR.




- Touch START.
- Data monitor results are shown on display.
Refer to "CONSULT-II Data Monitor" table.

For further information, read the CONSULT-II Operation Manual.