Odometer: Description and Operation

HOW TO CHANGE THE DISPLAY FOR ODO/TRIP METER
- The CAN communication signals (vehicle speed signal) from VDC/TCS/ABS control unit, and the memory signals from the meter memory circuit are processed by the combination meter, and the mileage is displayed.




- Operating the odo/trip meter switch allows switching the mode in the following order.
- The odometer/trip display switching and trip display resetting can be identified by the time from pressing the odometer/trip switch to releasing it.
- When resetting with trip A displayed, only trip A display is reset (same as trip B).

POWER SUPPLY AND GROUND CIRCUIT

Power is supplied at all times
- through 10 A fuse [No. 6, located in the fuse block (J/B) NO. 1]
- to combination meter terminal 39.

With the ignition switch in the ON or START position, power is supplied
- through 10 A fuse [No. 9, located in the fuse block (J/B) NO. 1]
- to combination meter terminals 40 and 42.

With the ignition switch in the ACC or ON position, power is supplied
- through 10 A fuse [No. 21, located in the fuse block (J/B) NO. 1]
- to combination meter terminal 28.

Ground is supplied
- to combination meter terminals 20 and 33
- through body grounds M24 and M114.