Active Test

ACTIVE TEST

Caution
- Do not perform the active test while driving.
- Active test cannot be started while ICC system warning indicator illuminates.

1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector and start engine.
3. Touch "START", "ICC", and "ACTIVE TEST" on CONSULT-II display in turn.
If "ICC" is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic
4. Touch necessary test item.
5. Touch "START".
6. Active test screen will be shown.

ICC Buzzer 1




- Touch "ON" and "OFF" to check that ICC warning chime operates as in the given chart.

ICC Warning Lamp




- Touch "ON" and "OFF" to check that ICC warning lamp operates as in the given chart.

Meter Lamp
- Start engine.




- Touch "ON" and "OFF" to check that ICC system display operates as in the given chart.

Stop Lamp




- Touch "ON" and "OFF" to check that stop lamp operates as in the given chart.

Booster SOL/V 3







- Touch any of "MODE 1", "MODE 2", "MODE 3" to check that following operation condition is caused by operating monitor and brake pedal.
- "START" is displayed 10 seconds after operation start. (Active test is completed.)