CONSULT-II Inspection Procedure For "IPDM E/R"

CONSULT-II INSPECTION PROCEDURE FOR "IPDM E/R"

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

"IPDM E/R"




1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector.
3. Turn ignition switch "ON".




4. Touch "START(NISSAN BASED VHCL)".




5. Touch "IPDM E/R".
If "IPDM E/R" is not indicated, go to "Data Link Connector (DLC) Circuit". Diagnostic Aids




6. Select diagnosis mode.
"SELF-DIAG RESULTS", "DATA MONITOR" and "ACTIVE TEST" are available.




Data Monitor




Active test